A universal base that turns your own center caps into floating center caps!
Even if your wheels are not on our fitment list, this base may fit if the dimensions match. The center cap (ornament) is not included. You modify and reuse your own center caps.
The mechanism is protected under Japanese Utility Model Registration No. 3256953.
About this product
- You choose this product by its dimensions, not by wheel model. Please compare the dimensions below with your own wheels and decide for yourself whether it will fit.
- Modifying the base or your caps may be required for installation. Any modification is at your own responsibility.
- Wheels we have confirmed, such as the WORK 60mm series (Seeker, LANVEC, etc.) and the GNOSIS series, have their own dedicated product pages. If your wheels are on our fitment list, please choose those instead.
Dimensions
| Item | 60mm | 70mm |
|---|---|---|
| Base plate diameter | 60.0 mm | 69.5 mm |
| Plate thickness | 1.4 mm | 1.4 mm |
| Overall height (bottom to tab tip) | 9.4 mm | 9.4 mm |
| Number of tabs | 6 (every 60°) | 4 (every 90°) |
| Tab width | approx. 13.5 mm | approx. 14.5 mm |
| Tab height | 8.0 mm | 8.0 mm |
| Tab outer diameter (root) | ø52.0 mm | ø56.0 mm |
| Tab outer diameter (hook) | ø54.0 mm | ø58.6 mm |
| Hook height | 5.1–6.5 mm | 4.1–4.8 mm |
| Tab inner diameter | ø48.0 mm | ø52.0 mm |
*Heights are measured from the top surface of the base plate (except overall height).
*The 70mm base has four low ribs between the tabs (outer diameter ø54.0–57.2 mm, height 3.0 mm).
*Listed dimensions have a manufacturing tolerance of about ±1%.
Three measurements to take on your wheel
1. Inner diameter of the center cap bore: must be larger than the base plate diameter.
2. Inner diameter where the tabs hook: must be larger than the tab root diameter and smaller than the hook diameter. The tabs flex inward and the hooks catch.
3. Depth from the bore floor (where the base plate sits) to where the tabs hook: must fall within the hook height range.
Please note
*Available as a single piece or as a set of 4 (one car). The set of 4 is better value.
*Sold while stock lasts. If sold out, the next release date is undetermined.
*We cannot accept returns or exchanges if the base does not fit, has been modified, or the modification failed. Returns and exchanges are accepted only for initial defects (such as cracked tabs or rotation failure before installation).
*We cannot verify fitment for individual wheels.
*On vehicles where the drive shaft protrudes, the cap may interfere.
*For assembly, please refer to the instruction manual (shared by VS / 60mm / 70mm).
*Orders placed in error cannot be exchanged or returned.
Floating Center Caps
Universal Floating Center Cap Base 60mm / 70mm
¥3,300 JPY
Translation missing: en.product.stock_note